• Settings Pike WR :
  Hook and CG: 100 from leading edge, CG: 103mm from leading edge
  (115mm from cone inside hook, CG 118mm from cone)
  Throws are based on Jo Grini's throws. Please make own adjustments.

Pike-WR 10/8-00		CG	103mm	Hook : 101mm from leading edge
Surface/acting as	Mode	Direction	Travel
Aileron/Aileron	start	up	12mm	all measured at wing tip, 20% expo
	speed	up	12mm
	Thermal	up	14mm
	start	down	2-3mm
	speed	down	4mm
	thermal	down	4mm
Flap/Aileron	start	up	5mm	all measured at wing root
	speed	up	5mm
	thermal	up	5mm
	start	down	3mm
	speed	down	3-5mm
	thermal	down	3mm
Aileron/Crow	All	up	12mm	at tip
Flap/Crow	All	down	90degr	at root
Elevator/crow mix	All	down	4/4,5mm	measurement at half/full crow at ele tip.
Elevator	All	up	6mm	all measured at tip, 20% expo
Elevator	Speed	up	apx 4mm	Max movement -9/+10
Elevator	All	down	6mm	Elevator central while flying thermal +1mm. (depp. CG/flap)
Elevator	Speed	down	apx 4mm
Rudder	race	up	6mm	60% expo. please no combi switch...
Rudder	thermal	up	6mm
Rudder	race	down	5mm	60% expo
Rudder	thermal	down	5mm
Speed flap (flap)	speed	up	1-2mm ?	Used in good air. Equal along all trailing edge, measurement taken at ail tip. NOT after entering the speed-task F3B
Speed flap (ail)	speed	up	1mm	Used in good air. Measured at tip
Speed flap (ele)	speed	down	0.8mm	Measured at tip. this is neutral in speed and distance.
Start flap (flap)	start	down	8mm
Start flap (ail)	start	down	3mm	Measured at tip
Start flap (ele)	start	down	1mm	Measured at tip
Thermal flap (flap)	thermal	down	2mm
Thermal flap (ail)	thermal	down	0.6mm	Measured at tip
snap flap (flap)	light air	down	3mm	Root. All snap flap is on a curve with max at 50% elev
Snap flap (ail)	light air	down	0.8mm	at tip
snap flap (flap)	good air	down	7mm	Root total with speed flap, careful with this much.
Snap flap (ail)	good air	down	1.8mm	at tip